Overview

HYM610 Tuning fork level switch is caused by the resonance of piezoelectric crystal vibration, when the material damping effect, the amplitude sharply reduced and frequency and phase changes significantly, these changes will be detected by the internal electronic circuit, after processing, converted into switching signal output.Tuning fork level switch can monitor, control and alarm the high and low level of the tank. It is suitable for all kinds of liquid, powder and granular solid.It is simple and practical, reliable operation, strong adaptability is basically free maintenance, tuning fork, and the output are all in working condition and leds indicate, status indication can be adjusted according to the habits, with three kinds of input methods (110 VAC,220VAC and 24 VDC) and multiple output mode (direct current output type, relay contact output type, dc voltage output type).All types have high or low fault alarm modes and optional instrument switch sensitivity.

Technical Parameters

Medium Temperature:-40℃～150℃

Environment Temperature:-20℃～70℃

Environment Humidity:≤95%RH

Medium:Liquid

Medium Density:minimum 0.6g/cm³ for liquid

Maximum Liquid Viscosity:＜1000mm2/s

Repose Angle of measured medium:≥200

Working Pressure:≤2MPa

Shell Material:Die cast aluminium alloy

Fork Material:1Cr18Ni9Ti

Electrical Interface:G1/2；G1

Process Connection:1”NPT thread installment（standard，BSPT optional）；flange installment（optional）Shell Protection:IP65

High-low signal Alarm:It can be set as HLFS (high alarm) or LLFS (low alarm)

Electrical Parameter:1.Supply:24VDC,220VAC,50Hz

2.Relay Output:8A,220VAC

                              Voltage Output:0~5V

                              Current Output:0~10mA

3.Power Consumption:0.5W

Tuning fork vibration frequency:300±50Hz

Ambient vibration level: V.L.4,acceleration is not greater than 1g

Switch signal action time:1～50s（optional）

Ordering Guide